INSTALLATION INSTRUCTIONS
READ & SAVE THESE INSTRUCTIONS!
Ceiling Fan Light Kits
Models: PFLK-123 Series
IMPORTANT: These Ceiling Fan Light Kits are for use with
NuTone Model PFOB-52 only.
CAUTION
SWITCH
HOUSING
1. CAUTION - To reduce the risk of fire and electrical shock,
this light kit should be used only with NuTone fan model
PFOB-52.
2. Read entire instructions carefully before beginning installation.
PIPE, NIPPLE,
NUTS, ETC.
COVER PLATE
3. CAUTION - To reduce the risk of electrical shock, disconnect
the electrical supply circuit to the fan before installing the light
kit.
4. All wiring must be in accordance with national and local
electrical codes. If you are unfamiliar with wiring, you should
use a qualified electrician.
FIGURE 1
MAKING THE CONNECTIONS
NOTE: See fan instructions for connecting house wiring to the
fan. Connect house wiring to the fan before attaching light kit to
the fan. See wiring diagrams on back of this page, titled wiring
wall switches.
FAN AND LIGHT ON A SINGLE WALL SWITCH
WHITE
WIRE
WHITE WIRE
115 VOLT SUPPLY
BLACK WIRE
WITH TRACER
OR BLUE WIRE
1. Refer to Figures 1. Remove the cover plate from the bottom
of the fan switch housing.
BLACK WIRE
2. Assemble the cover plate to the light kit as shown. Use the
pipe nipple and nuts provided.
MOTOR
CONNECTIONS
(NON-ACCESSIBLE)
3. Locate the two wires in the fan switch housing that have
labels marked “Connect Light Here” or “For Light Use”.
One wire will be white and the second will be black or blue
with or without white tracer. Connect these wires to the wires
coming from the light kit. Assemble the light kit to
the fan using the screws removed in step 1 (one) above.
Re-assemble bottom cover and pendent to the fan. Proceed
to completing the Installation.
CEILING
FAN
BLACK WIRE
WITH TRACER
OR BLUE WIRE
WHITE
WIRES
WALL
SWITCH
BLACK
WIRE
LIGHT KIT
FIGURE 2
COMPLETING THE INSTALLATION
1. Install (1) 100 watt maximum light bulb. Note: Refer to the
guide for maximum size bulb that is printed on the
light fixture.
FAN AND LIGHT ON SEPARATE WALL SWITCHES
WHITE
WIRE
2. Should light shade begin to buzz, be certain all
thumbscrews are tight.
WHITE WIRE
115 VOLT SUPPLY
BLACK WIRE
WITH TRACER
OR BLUE WIRE
WIRING WITH WALL SWITCHES
The Ceiling Fan and Light Kit can be connected
through wall switches. This can be done in two ways.
Select the type of control desired and wire the unit
according to Figure 2 or Figure 3.
BLACK WIRE
MOTOR
CONNECTIONS
(NON-ACCESSIBLE)
Use one wall switch to control both fan and light.
Individual control of either fan or light is done with the
pull chain switches.Or use two wall switches to
individually control both fan and light – one for the fan
and the second for the light. Pull chain switches on
the fan do not have to be used.
CEILING
FAN
BLACK WIRE
WITH TRACER
OR BLUE WIRE
WHITE
WIRES
WALL
WALL
SWITCH
FOR
BLACK
WIRE
SWITCH
FOR FAN
LIGHT KIT
LIGHTS
FIGURE 3
|