CD/MS Multi-Source Receiver with Fully Motorized VF Face
MODEL
CD Multi-Source Receiver with Fully Motorized Face
MODEL
INSTALLATION MANUAL
Be sure to read this installation manual thoroughly prior to installation and making connections. If
installation methods or non-standard parts not specified in this installation manual are used, accidents
or injury may result.
Professional installation is recommended, contact the place of purchase to schedule an appointment.
After reading the owner's manual and the installation manual thoroughly, keep them in a safe place for
later reference.
To dealers:
Give this installation manual to the customer after installation and all connections have been
completed.
Contents
Before
installation
Components
2
3
For your safety in using the CD5000 or CD4000
Names and functions of terminals
System connection example
5
8
Connections
Installation
Installing the main unit
11
For your safety in using the CD5000 or CD4000
Warnings and caution signs, illustrated below, are posted throughout this manual as well as on the CD5000
and CD4000. They show safe and correct ways to handle the main unit to prevent personal injury to you and
others and avoid damage to property.
Before reading through the manual, take time to read through and learn the important information listed in
this section.
This "Warning" sign indicates a situation in which incorrect handling may
result in death or serious personal injury.
This "Caution" sign indicates a situation in which incorrect handling may
result in personal injury or may result solely in damage to property.
This section contains information that can help to prevent problems and
Tip
damage to the main unit, and also contain other useful information.
• Do not install this main unit in locations where it may
obstruct the driver's view, or where it may endanger
passengers in the vehicle. Otherwise, an accident or
injury may result.
• Never supply power to another electrical appliance
by splicing or tapping into this main unit's power wire.
Otherwise, the current capacity of the wire will be
exceeded, resulting in a fire or electric shock.
• Do not install this main unit in locations where it may
interfere with the operation of the steering wheel,
shift lever, brake pedal, etc. Otherwise, an accident
or injury may result.
• Never attempt to disassemble or modify the main
unit. Otherwise, an accident, fire, or electric shock
may result.
• When installing the main unit into a vehicle with a
passenger side air bag, do not secure it to the air
bag's cover or in places where it may impede air bag
deployment. Otherwise, proper air bag operation may
not be ensured in the event of an accident, causing
injury or death.
• To prevent damage to the vehicle, confirm the
locations of hoses, electrical wiring, and the fuel tank
prior to drilling holes to install this main unit. Also,
take precautions so that the main unit does not
interfere, nor come in contact with them. Otherwise,
a fire may result.
• When making holes (example: drilling) be sure to
wear protective eyewear. Otherwise, an injury such
as loss of eyesight may result.
• When installing this main unit, never use the existing
nuts or bolts that secure parts of the fuel tank, or the
steering, or braking systems. Otherwise, improper
steering, or braking or a fire may result.
• Exposed wires must be insulated with electrical tape.
Otherwise, a short circuit, fire, or electric shock may
result.
• To prevent a short circuit from occurring, disconnect
the battery's negative terminal before installing this
main unit. Otherwise, an electric shock or injury may
result.
• Do not modify this system for use other than that
specified herein. Also, do not deviate from the
installation procedures described herein; Eclipse will
not be held liable for damages including, but not
limited to serious injury, death, or property damage
resulting from installations that enable unintended
operation.
• When using an existing nut and/or bolt from the
vehicle to ground this main unit, do not use any that
secure parts of the steering or braking systems.
Otherwise, an accident may result.
• Bundle wires and harnesses with electrical tape or
wire ties to prevent them from interfering with moving
parts. If they should entangle with the steering wheel,
shift lever, or brake pedal, an accident may result.
• This main unit is intended for operation in DC 12volt,
negative-grounded vehicles only. Never use it in 24-
volt vehicles such as heavy trucks or diesel vehicle
with cold-region specifications.
- -
3
• Do not place the vinyl storage bag over a person's
head. It may cause a serious accident or death by
suffocation.
• Do not operate the main unit in a malfunctioning
condition, for instance, when the audio does not play.
Doing so may result in an accident, fire, or electrical
shock.
• Do not disassemble or rebuild this main unit. Doing
so may cause an accident, fire, or electrical shock.
• If an abnormal situation occurs, such as foreign
matter entering or liquid splashing on the main unit,
or smoke or a strange odor emitting from the main
unit, shut off the main unit immediately and consult
the dealer from whom you purchased it. Continued
operation may cause an accident, fire, or electrical
shock.
• When it is necessary to replace the fuse, always use
a fuse of the correct rating (number of amperes). Use
of fuses with higher amperage ratings may cause a
fire.
• For best results, this main unit should be installed by
a professional installer.
• This main unit must be operated only as on-board
main unit, or it may cause electrical shock or injury.
Contact the dealer whom you purchased the main
unit for an appointment.
• Do not play distorted sounds for long periods of time;
the speakers may overheat and cause a fire.
• When installing this main unit, be sure to use the
supplied mounting hardware. If parts other than
those supplied are used, the main unit may be
damaged internally, or may not be held in place
securely and become dislodged.
• Use supplied wire harness with this main unit. Other
manufacturers may use a similar wire harness
connector but pin configurations are incorrect for use
with Eclipse main units and can damage the main
unit. Prior to powering up the main unit, please make
sure the main unit is properly grounded with the
vehicle chassis. If no ground is available to the
chassis, add a ground strap from the main unit to the
vehicle chassis to improve the ground.
• Avoid installing this main unit in places where it may
get wet, such as near windows, or in places that are
moist or dusty. Presence of liquid, moisture, or dust
inside this main unit can cause short circuiting
resulting in smoke or fire.
• Do not use with speakers having 1 to 3 ohms
impedance. This main unit is designed to be used
with high-powered speakers rated above 50w with
impedance rating between 4 and 8 ohms.
• If this main unit is not connected properly, a short
circuit, fire, or accident may occur.
• When routing wires, use precautions to prevent
contact of sharp metal parts such as brackets or
screw tips. Otherwise, a short circuit, electric shock,
fire, or accident may result.
• Play the audio at a moderate volume level that
permits you to hear sounds from outside the vehicle.
Driving without being able to hear outside sounds
may result in an accident.
- -
4
Name and functions of terminals
•
•
Never cut the insulation on the power wire or use it to power any other equipment. If the rated current
capacity of the power wire is exceeded, fire and electric shocks may result.
The wires should be secured with tape or a similar securing method to prevent any obstructions while
driving. If they get wound or entangled around components such as the steering wheel, shifting lever,
or brake pedal, accidents may result.
• If removing the end of the wire to connect to another wire, be sure to wrap PVC tape or a similar wire
insulating method around the connection to insulate it. If the connection is not insulated, fire or
accidents may result.
•
Use supplied wire harness with this main unit. Other manufacturers may use a similar wire harness
connector but pin configurations are incorrect for use with Eclipse main units and can damage the main
unit. Prior to powering up the main unit, please make sure the main unit is properly grounded with the
vehicle chassis. If no ground is available to the chassis, add a ground strap from the main unit to the
vehicle chassis to improve the ground.
• Do not use with speakers having 1 to 3 ohms impedance. This main unit is designed to be used with
high-powered speakers rated above 50w with impedance rating between 4 and 8 ohms.
A
B
C
D
E
MAIN UNIT
1
ANTENNA PLUG
16P
F
CD5000 only
※
1
2
4
7
5
6
3
8
2
INTERCONNECTING WIRES
(Power and speaker connector)
9
Tip
2
•
•
Refer to page 6 for details on the wire colors and connection points for interconnecting wires
.
Refer to page 7 for details on connection points
terminals.
～
for the main unit wires and
A
F
- -
5
2
Wire colors and connection points for connection wires
Never connect the power supply to the speaker wires (No.7 and No.8),
otherwise it will cause damage to the main unit.
Caution
1
ACC (Red)
Connect where the power comes on when the ignition is in the ACC position.
2
B+ (Yellow)
Connect where power is constantly available, regardless of the ignition key's position.
3
Ground (Black)
Connect where good body grounding is available.
4
Antenna power supply (Blue)
Connect to the automatic-antenna control terminal of the vehicle.
5
Illumination power supply (Orange/White)
Connect to where power comes on when the vehicle light switch is turned on.
6
Control power supply (Blue/White)
Connect the control terminal for the external amplifier, etc.
7
Front speaker output wires
Connect to the front speakers.
White: Left +
Gray: Right +
White/black:
Gray/Black:
Left -
Right -
8
Rear speaker output wires
Connect to the rear speakers.
Green: Left +
Green/black:
Purple/Black:
Left -
Purple: Right +
Right -
9
Genuine factory steering remote control terminal
Connect to the vehicle steering remote control.
Compatible vehicle models for installation : Vehicles with voltage detection-type steering remote control.
Ask your dealer for details.
※
- -
6
Main unit connections
Front line-out terminals
A
Connect to the RCA connector of an external amplifier.
Rear line-out terminals
B
C
D
Connect to the RCA connector of an external amplifier.
Line-out terminals (Non fader)
This is used for non fader output. It can be used as a sub-woofer terminal if a separate amplifier with
a low bass filter is connected.
AUX in terminals
Connect if using together with portable audio equipment that is sold separately.
* If the output from the connected equipment is via a mini plug, it will need to be converted to RCA.
(CD5000 only)
E-LAN terminal (13P)
E
Connect to the E-LAN terminal of the CD changer, etc.
(CD5000 only)
LAN terminal
(8P)
F
Connect to the LAN terminal of GPS unit.
-
Vehicle connections
-
Tip
• You will need to purchase the necessary vehicle component adapter wire for the vehicle so that the
power supplies can be utilized. (Contact the dealer for further details.)
• Be sure to wrap the connection wires with electrical tape or another insulation method to insulate them.
-
Example of using vehicle adapter wires
-
Vehicle harness
Power supplies
for combined
equipment
From main unit
Vehicle component adapter wires
- -
7
System connection example
•
•
Never cut the insulation on the power wire or use it to power any other equipment. If the rated current
capacity of the power wire is exceeded, fire and electric shocks may result.
The wires should be secured with tape or a similar securing method to prevent any obstructions while
driving. If they get wound or entangled around components such as the steering wheel, shifting lever,
or brake pedal, accidents may result.
• If removing the end of the wire to connect to another wire, be sure to wrap PVC tape or a similar wire
insulating method around the connection to insulate it. If the connection is not insulated, fire or
accidents may result.
Tip
• Install and connect all of the peripheral equipment before connecting them to the main unit.
• Do not remove any of the protective caps (RCA, etc.) unless in use.
• Be sure to wrap the connection wires with tape (PVC tape) to insulate them.
• Adjust the external amplifier’s input level.
■System for the CD5000
1) CD5000 Main unit, used alone
NO CONNECTION (Do not remove cap)
NO CONNECTION (Do not remove cap)
NO CONNECTION (Do not remove cap)
NO CONNECTION (Do not remove cap)
NO CONNECTION
MAIN UNIT
1
ANTENNA PLUG
16P
NO CONNECTION
Red
White
TO ACC (Power Supply)
Yellow
White/Black
TO BATTERY+12V (Permanent Supply)
Blue
FRONT
Gray
Gray/Black
Green
TO POWER ANTENNA RELAY (Supply)
SPEAKERS
Orange/White
TO HEAD LIGHT SWITCH (Illumination (+) )
Blue/White
Black
TO TURN-ON WIRE OF EXTERNAL EQUIPMENT (Supply)
Green/Black
Purple
TO GROUND
REAR
SPEAKERS
Purple/Black
2
INTERCONNECTING WIRES
(Power and speaker connector)
Brown
TO STEERING REMOTE CONTROL
Brown/Black
- -
8
2) CD5000 + HDR105 + CH3083 + VRM803 + Power Amplifer
VRM803
(sold separately)
L SIDE
NO CONNECTION (Do not remove cap)
TO BATTERY+12V
NO CONNECTION
(Permanent Supply)
(Do not remove cap)
TO SIGNAL INPUT OF AUXLIARY
POWER AMPLIFIER
TO GROUND
NO CONNECTION
ANTENNA PLUG
2P
MAIN UNIT
1
HDR105
(sold separately)
ANTENNA EXTENSION WIRE
16P
13P
13P
13P
White
Yellow
TO BATTERY+12V
(Permanent Supply)
NO CONNECTION
(Do not remove cap)
White/Black
INSULATE EACH WIRE WITH NONE
CONDUCTING TAPE SUCH AS
PLASTIC TAPE OR ANOTHER
INSULATING METHOD
13P
2P
Gray
Gray/Black
CH3083
Green
Green/Black
Purple
(sold separately)
TO GROUND
Red
TO ACC (Power Supply)
INSULATE EACH WIRE WITH NONE
CONDUCTING TAPE SUCH AS
PLASTIC TAPE OR ANOTHER
INSULATING METHOD
Blue
INTERCONNECTING WIRES
(supplied with CH3083)
TO POWER ANTENNA RELAY (Supply)
TO HEAD LIGHT SWITCH (Illumination (+) )
Orange/White
Purple/Black
Blue/White
TO TURN-ON WIRE OF EXTERNAL EQUIPMENT (Supply)
Brown
TO STEERING REMOTE CONTROL
Brown/Black
Black
TO GROUND
2
INTERCONNECTING WIRES
(Power and speaker connector)
■System for the CD4000
1) CD4000 Main unit, used alone
NO CONNECTION (Do not remove cap)
NO CONNECTION (Do not remove cap)
NO CONNECTION (Do not remove cap)
NO CONNECTION (Do not remove cap)
MAIN UNIT
1
ANTENNA PLUG
16P
NO CONNECTION
Red
White
TO ACC (Power Supply)
TO BATTERY+12V (Permanent Supply)
TO POWER ANTENNA RELAY (Supply)
Yellow
White/Black
Gray
Blue
FRONT
SPEAKERS
Orange/White
Gray/Black
Green
TO HEAD LIGHT SWITCH (Illumination (+) )
Blue/White
Black
TO TURN-ON WIRE OF EXTERNAL EQUIPMENT (Supply)
Green/Black
Purple
TO GROUND
REAR
SPEAKERS
Purple/Black
2
INTERCONNECTING WIRES
(Power and speaker connector)
Brown
TO STEERING REMOTE CONTROL
Brown/Black
- -
9
|